Operating instructions

Page 10 of 16 Installation and Operating Instructions SC-411HS-20

4/1/14 CP5122A

PA VOLUME PROGRAMMING

PA volume setting (programming) is done from the face of the handheld controller. Unit must be turned on with

POWER input. Make sure that all buttons are off.

Enter the program mode by pressing and holding the

PA button and DIM button for 3 seconds.

The unit will beep 3 times and the backlighting will begin

flashing to indicate that the unit is in program mode. It will

continue to flash until program mode is stopped by press-

ing and holding DIM for 3 seconds, saving the settings—

the unit will emit a long beep.

Set the volume by momentarily pressing S1, S2, S3 or

S4. The corresponding light will turn on.

Press the DIM button for 3 seconds to save & exit.

DIM

Med