Dual Remote Siren Amplifier With Mechanical Tone Installation & Operating Instructions

Page 6 of 15 SA-441-17 Installation and Operating Instructions
CP5008A 07/29/08
OPTION SWITCHES
An 8-position DIP switch on the remote amplifier may be changed to select various options.
SW-1 Two-Tone - Turn this switch on to replace Phaser tone with Two-Tone.
SW-2 Mechanical Override - Pressing the Siren push-button normally produces Horn tone
while the rotary function switch is in Mechanical. Turn this switch on to manually override
Mechanical tone instead.
SW-3 SW-4 Siren push-button and Auxiliary Input Function
with Rotary Selector Switch in Standby
OFF OFF (Default) Produces Horn tone while pressed.
ON OFF Manual control of Mechanical tone.
Also Mechanical tone continues to fall when Rotary
Selector Switch is changed from Mechanical position.
OFF ON Manual control of Wail tone.
ON ON Activates Horn Ring Cycler 2 (HRC2) function.
SW-5 thru SW-8 - Not Used… Leave Off.
Horn Ring Cycler 2 (HRC2) - Turn on DIP SW-3 and SW-4 to enable this feature. Also
connect the auxiliary input to the horn ring or other switch. While the siren is in standby, tap the
horn ring to bring the unit out of standby into Mechanical tone. Repeatedly tapping the horn
ring will cycle through Mechanical, Wail, Yelp, and Phaser tones. Tapping the horn ring twice
quickly will stop the siren tones and return the unit to standby. Pressing and holding the horn
ring will produce Horn tone until released. Then the siren will return to its previous siren tone or
standby.
Dual Mode version of HRC2 sequences as described in the following table.
Sequence (Loops) Dual HRC2
Spkr 1 Spkr 2
Mechanical Mechanical
Wail Yelp
Yelp Mechanical
|
|
|
I
V
Phaser Mechanical
Option Switches
On Remote Amp
ON
1 2 3 45678
Option Switches
Default Setting (Shown) all OFF (UP)