Carson MANUFACTURING COMPANY, INC. SA-400 SIREN AMPLIFIER RADIO SIREN HORN Carson MAN WAIL YELP PHASER O F F SASA-400 PA VOL O N INSTALLATION AND OPERATING INSTRUCTIONS 5451 N. Rural Street Indianapolis, IN 46220 Phone: (888) 577-6877 Fax: (317) 254-2667 Website: www.carsonsirens.
Page 2 SA-400 Installation and Operating Instructions TABLE OF CONTENTS GENERAL DESCRIPTION.......................................................................................3 SPECIFICATIONS ....................................................................................................3 INSTALLATION ........................................................................................................4 SAFETY PRECAUTIONS ...........................................................................
SA-400 Installation and Operating Instructions Page 3 GENERAL DESCRIPTION The SA400 Siren Amplifier is a premium unit designed for single or dual 100W speaker use from a 12 volt DC power source (negative ground). A 6-position rotary switch controls the primary operating modes of Phaser, Yelp, Wail, Manual, Horn and Radio. A Siren control button is provided for control of the output tone when in the Manual mode, and control of Horn and Yelp Overrides, depending on the function switch setting.
Page 4 SA-400 Installation and Operating Instructions INSTALLATION Proper installation of the unit is essential for years of safe, reliable operation. Please read all instruction before installing the unit. Failure to follow these instructions can cause serious damage to the unit or vehicle and may void warranties. SAFETY PRECAUTIONS For the safety of the installer, vehicle operator, passengers and the community please observe the following safety precautions.
SA-400 Installation and Operating Instructions Page 5 MOUNTING The mounting bracket supplied can be installed above or below the unit. Choose a mounting location convenient to the operator and away from any air bag deployment areas. Inspect behind mounting area for clearance. Assure adequate ventilation to prevent overheating. Consider wire routing and access to connections, as well as microphone bracket placement. Install mounting bracket to vehicle using 1/4" hardware (not supplied).
Page 6 SA-400 Installation and Operating Instructions OPERATION GENERAL This unit is designed for easy operation under the stress associated with high-speed pursuit. Most siren functions are accessible with one simple motion without repetitive activation of switches or automatic timed switching that can interfere with desired operation. SELECTOR SWITCH The 6-position rotary selector switch controls the primary operating function of the siren.
SA-400 Installation and Operating Instructions RADIO VOLUME The radio repeat volume level is set using an adjustment inside the case just behind the PA volume control. Press on the rear of the case to open the unit, then set the Selector Switch to the Radio position and turn on the power. With the radio volume set to normal level, adjust the siren radio repeat control to the desired level. Turn off power and press the unit back into the case.
Page 8 SA-400 Installation and Operating Instructions SERVICE This unit is designed to provide years of reliable service under even the worst conditions. Many times there may appear to be a problem with the unit when the true problem is in the speaker(s) or improper installation. The following chart shows typical symptoms and possible causes. A blown rear panel fuse doesn't necessarily mean that the unit is bad. If a speaker or speaker lead is shorted this fuse will blow before the unit is damaged.
SA-400 Installation and Operating Instructions Page 9 PARTS The following parts are available from Carson Manufacturing Company, Inc.: Part CP3966 CP3633 CP3571 CP4732 CP3547 ES00026-03 ATO/ATC 20A CP4702 CP4824 CP4826 ED1680 CP2560 CP4825 CP4750 8025 DRS/CAP SR-15-1 CP4822 CP3962 CP3548 CP4119 CP4825A Description Bolt, 1/4-20 x 3/8" Hex Locking Bracket, Microphone with Screws Bracket, Mounting Control, 1K Vertical Trimmer Control, 350 Ohm Mini-Pot Cover, Std.
Page 10 SA-400 Installation and Operating Instructions RETURN If you have any questions concerning this or any other Carson product, please contact our Technical Service Department at (888) 577-6877. Many issues can be handled over the phone. We can also be reached via e-mail at service@carsonsirens.com If a product must be returned for any reason, please contact our Technical Service Department to obtain a Returned Merchandise Authorization number (RMA#) before you ship the product to Carson.
SA-400 Installation and Operating Instructions Page 11 LIMITED WARRANTY Carson Manufacturing Company, Inc. warrants this new product to be free from defects in material and workmanship, under normal use and service, for a period of five (5) years from the date of delivery to the first userpurchaser.
Page 12 SA-400 Installation and Operating Instructions INSTALLATION INFORMATION MODEL: SA-400- __________________ OPTIONS SERIAL NO: ______________________ _____ Two-Tone enabled PURCHASE DATE: _________________ _____ Phaser disabled DEALER: _________________________ _____ Horn disabled INSTALL DATE: ____________________ _____ HRC enabled INSTALLER: _______________________ _____ Short Manual enabled AUX CONNECTION: ________________ _____ Radio Input connected Model and serial number located
