Instruction manual

56
GB
CARSON Reflex Wheel Ultimate Touch 500500516
1. Insert the TX battery in the compartment on the
underside of the remote control and close the
compartment again with the closure cover.
2. Connect the USB charger lead supplied to a USB
230V adapter.
3. The mini USB connecter must now be connected
to the USB port, which is located on the back of
the transmitter.
4. Next insert the USB 230V adapter into the socket.
Charging will now start. Alternatively, you can
also connect the USB charger lead to a computer.
Warning!!!
Please always check before using your RC system
that the RX and TX batteries are fully charged;
otherwise you may lose control of your model.
Use only an appropriate charger for charging the
batteries, as otherwise the battery may overheat,
ignite or explode.
Separate the charger lead from the transmitter once
the battery is fully charged. If you do not intend to
operate your RC system any longer, remove the TX
battery before storing.
Always observe the safety instructions contained in
the manual.
Connection to the PC or to
a USB socket adapter
Charging the TX battery