User's Manual

Using the microscope to view objects directly
1. Make sure the base plate sits beh
ind the battery door in the upright position (Fig.4).
2. Press the LED switch to turn on the LED (Fig.5). Please note tha
t when base plate is in upright position
only front facing LED will illuminate.
3. Place the viewing object directly below the objective lens (Fig.6).
Using the microscope to view specimen slides
Fig.10
Fig.12
F
ig.11
Fig.4 Fig.5
Fig.6
Adjusting zoom & focus
1. Adjust the zooming dial to the d
esired level
of magnification (Fig.10).
2. Rotate the focusing ring until the image is
sharp and clear (Fig.11).
WARNING:
Do not look directly
at the UV light.
Press and hold the UV light switch to activate the
UV light (Fig.12).
NOTE: The UV light is deactivated when the base
plate is flipped down to the base of the microscope.
1. Flip the base plate down so that it sits on the base of the microscope (Fig.7).
2. Press the LED switch to turn on the LED (Fig.8). Please note that when base plate is down only downward
facing LED will illuminate.
3. Insert the specimen slide into the slot between the objective lens and the base plate (Fig.9).
Fig.7
Fig.8 Fig.9
1.
UV light