User Manual

TO REMOVE PHONE FROM ADAPTER:

To save your alignment, make no further adjustments to the top clamp and alignment

knob. Simply remove phone using right clamp only as shown in Fig. 4.

USING ADAPTER AGAIN:

The alignment of your phone to the adapter should be saved from the initial setup, so

many steps can be skipped (FIG 1-2, 7-10) and only a quick fine adjustment of the

alignment may be needed.

Frequently Asked Questions:

Q1: The top clamp touches the round corner of my phone not the top flat edge of my

phone. What do I do?

A1: This is normal for some models of phones. Just push as flush to rounded edge as

possible and lock top clamp as normal.

Q2: I am getting reflections and/or glare in my image, what do I do?

A2:

If there are bright spots in the image itself, this may occur with indoor lighting,

please avoid overhead lighting or change the angle over the overhead lighting relative

to phone. Also, please use without flash to avoid reflections and/or glare in photos. If

there is glare on your phone screen which makes image hard to view, then increase the

brightness setting on your phone, and/or try to view from a position with less overhead

lighting.