User Guide

TB0326B Page 5 of 8 10/18/03
OPERATION
Sound Hazard - Sound level from siren speaker (>120dBA @ 10 feet) may cause hearing damage.
Do not operate siren without adequate hearing protection for you and anyone in immediate vicinity.
(Ref. OSHA 1910.95 for occupational noise exposure guidelines)
RADIORADIO
PAPA
MANMAN
WAILWAIL
YELPYELP
TWO TONETWO TONE
SIRENSIREN
P.A. VOLUMEP.A. VOLUME
WSWS--295295
ONON
OFFOFF
The OFF/ON Toggle Power Switch controls the siren power. The siren may be left on any time the vehicle is in
operation. The power should be turned off when vehicle is not being used to conserve battery power.
The Rotary Function Switch selects various operating modes. These modes are as follows:
RADIO - This mode reproduces, or repeats, the output of a radio. The radio must be connected and
RADIO VOLUME ADJUSTed for this mode to function. No overrides available in this mode.
PA - Also considered a standby mode. Horn and PA Override available in this mode.
MAN - The siren tone is controlled Manually with SIREN button. PA Override available in this mode.
WAIL - The siren produces a normal rise-fall tone pattern. This mode should be used on highways or
areas with constant traffic flow. Yelp and PA Override available in this mode.
YELP - The siren produces a moderate warble tone. This mode should be used in lightly congested
areas. Horn and PA Override available in this mode.
TWO TONE - The siren produces two alternating frequencies like the European. This mode should be used
at intersections or in highly congested areas. Horn and PA Override available in this mode.
OVERRIDE FUNCTIONS
PUBLIC ADDRESS
(PA) OVERRIDE - By pressing the microphone button any siren tone output is turned off, allowing the operator to
use the siren as a public address amplifier. The siren tone resumes when the button is
released. (Hold the microphone close to your lips for proper operation and adjust the PA
Volume Control)
HORN OVERRIDE - By pressing the SIREN button the siren tone output is replaced by the horn tone. The siren
tone resumes when the button is released. (This feature is not available in WAIL mode.)
YELP OVERRIDE - Available only in WAIL mode. By momentarily pressing the SIREN button the tone output is
switched to the Yelp tone. Pressing the button again switches the tone output back to Wail.