User manual

• The remote-controlled model may only suitable terrain and not on public traffic areas are operated.
• Do not go near people or animals!
• Do not drive, when you are tired or otherwise impaired in their ability to react are.
• Always maintain direct visual contact with the model.
• Always drive only with a properly mounted attached body.
• Regular maintenance is necessary for first-class driving performance.
• The model has parts that heat up during operation, eg the top of the engine transmission, the metal
and much more. Do not touch them after the operation, may lead to injury.
• Ensure the charge status display of your transmitter.
• With half-empty Batteries, you can lose control of the model.
• Do not mix batteries in the transmitter never full / half empty batteries or batteries of different
Capacity.
• Never try to charging no rechargeable batteries (only batteries are rechargeable).
Instructions for use:
Product Features
- RC model with 27 MHz Remote Control.
- Grade ability up to 20 degrees.
Scope of delivery
1. RC-Model in 1:14 scale
2. 27 MHz Remote Control
3. 4,8V/800mAh rechargeable NiMH battery
4. DC 6V/200mA, plug-in charger
5. Operating Instructions
Installing the transmitter antenna (see drawing)
1. Insert the included antenna into the hole located upper side of the transmitter.
2. Screw the transmitter antenna gently clockwise into the transmitter housing.
3. Please make sure that the thread is not stripped.
Insert the battery in the remote control (see drawing)
1. Turn to open the battery compartment out there the attached screw counterclockwise with a
screwdriver.
2. Insert a fresh 9V battery according to the polarity of prefabricated into the battery compartment.
3. Close the battery compartment cover and turn the screw clockwise again prudently.
4. Slide the switch on the front panel to "ON". Lighting up a LED light indicates that the batteries are
inserted correctly.
Insert the batteries into the model
1. Turn to open the battery compartment on the bottom of the model mounted there screw
counterclockwise.
2. Connect the fully charged battery on the intended plug in the battery compartment. Pay attention to
the correct polarity.
3. Close the battery compartment cover and turn the screw clockwise firmly back.
4. Activate the model, slide the switch to "ON".
Note: Charge the battery for the first time 5 hours, up from the second time 4 hours.