User manual
43CARSON DRAGSTER Brushless-Regler
GB
13. Selecting a Pre-programmed driver Profiles
(Throttle/Brake Settings)
Profiles 1 - 4 have no influence on the undervoltage protection set at the time
when you selected the type of battery.
Driver profile 1 2 3 4 reset to
factory
defaults
5
Cut-Off as
selected
as
selected
as
selected
as
selected
NiMH
Reverse travel no yes yes no yes
Percentage
reverse travel
050500 25
Initial braking
performance
30 % 30 % 40 % 40 % 30 %
Parking brake 15 % 10 % 15 % - 10 %
Dead Band 3 3 4 4 3
• Press the SET button down until the blue LEDs light up 6 times. Release the
SET button again.
• The red LED start flashing. This shows that you are in the mode for setting the
driver profile.
• Press the SET button repeatedly until you reach the required setting. The red
LED flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through the
settings.
• When you reach the required setting, hold down the SET button for approx. 2
seconds; the setting is stored.
• Once you have stored the setting, the red and blue LEDs flashes alternate 3
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.