User manual

41CARSON DRAGSTER Brushless-Regler

Flashing

frequency

1 2345678910

Drag brake (%) OFF 5 10 15 20 25 30 35 40 45

11. Setting the Drag Brake (Engine Brake)

The drag brake simulates the friction of the brushes of brush motors.

• Press the SET button down until the blue LED light up 4 times. Release the SET

button again.

• The red LED start flashing. This shows that you are in the mode for setting the

parking brake.

• Press the SET button repeatedly until you reach the required setting.

The red LED flash at the next highest speed.

• By repeatedly pressing briefly on the SET button you can scroll through the

settings.

• When you reach the required setting, hold down the SET button for approx. 2

seconds; the setting is stored.

• Once you have stored the setting, the red and blue LEDs flashes alternate 3

times to show that you are leaving the programming mode. Switch controller

off and on again to activate the selected settings.

• If you do not press the SET button for more than 10 seconds the

controller reverts to the last setting and is ready for use again.

Blue LED

Red LED