User manual

44
GB
CARSON Air Zermatt SA 315B „Lama“ 50 050 7041
Please read this before something happens.
Problem Cause Reparation
The model does not move 1. Check whether the transmitter and the receiver
are switched on
Switch transmitter and/or receiver on
2. Check the battery voltage of transmitter and
receiver
Employ completely charged batteries
3. The trim slider of the pitch-function stands on the
upper stop
Ensure that the trim slider of the pitch function is
in neutral position or somewhat below
Motor does not turn 1. Motor is defective Exchange the motor
2. Motor is too hot Allow the motor to cool down
The model reacts
incorrectly to the control
commands or flies
choppily
Check the state of the transmitter and receiver battery
charges
Employ completely charged batteries
The model does not
take off
1. Rotor blades are twisted Exchange the rotor blades
2. Motor is too hot Allow the motor to cool down
3. Batteries are empty Charge the batteries or exchange them
The rotors do not allow
shut down
Trim is not correctly adjusted Correct the trim on the pitch controller
The model moves forward/
backward and sidewise, but
does not hover
Check whether the helicopter is exposed to a draught, e.g.
by an opened window or an air conditioner. Hover flight is
not possible when there is a draught
Close the window/door, switch off the air
conditioner or select a more suitable room
The model vibrates severely 1. Check whether the principal rotors run true Possibly change the rotor blades
2. Check whether the model is correctly balanced Possibly change the rotor blades
The tail does not permit
stabilizing
1. One or more rotor blades are defective Replace one or both rotor blades
2. Lower and upper rotor revolution run with different
friction on the rotor shaft
Ensure that both rotor revolutions allow for easy
rotation
3. The velocity of rotation of the upper and lower rotor
revolution is uneven
Correct the trim on the transmitter
n. Troubleshooting