User manual

11CARSON Specter Two Brushless 50 040 9000

h. How to Change Frequencies

Transmitter

A rapid change of frequencies is possible simply by unplugging

an interchangeable plug in crystal on the back of the

transmitter and then

plugging in another one

of a different frequency.

Crystals for both the

transmitter and receiver

must be matched with

each other.

Make sure that the

crystal is fully inserted

in the transmitter and

receiver, not partially.

Receiver

Plug in an interchangeable crystal into the receiver for a rapid

change of frequencies.

Crystal

i. Troubleshooting

Problem Cause Correction

Model doesn´t move Transmitter or chassis power switch is not „ON“ Switch power on

Polarity or battery type is wrong Check polarity and type

Batteries have run down Change batteries or charge them

Loss of control Batteries have run down Change batteries or charge them

Antenna is missing or not attached properly Attach antenna and extend transmitter

antenna to full length

R/C model using same band (frequency) is

nearby

Run model in different area or change crystal

Doesn´t run straight Steering trim is not adjusted correctly Make adjustment

Front and rear wheel nuts are too lose Tighten wheel nuts

Doesn´t stop Throttle trim is not adjusted correctly Make adjustment

Doesn´t reverse Throttle trim is not adjusted correctly Make adjustment

Wrong action Control properly

Running too slowly Batteries have run down Change batteries or charge them

Motor has lost power Change to spare motor

Rear wheel nuts are too loose Tighten wheel nuts

Dust or foreign objects are inside gears Turn the power switch „OFF“ and clean out

gears