User manual

28
GB
CARSON Brushless Speed Controller Dragster 6S
Trouble Possible reason Solution
After power on, motor doesn’t
work
The connections between
battery pack and ESC are not
correct
Check the power connections
Replace the connectors
After power on, motor doesn’t
work, but emits “beep-beep-,
beep-beep-” alert tones
(Every group of “beep-beep-”
has a time interval of 1 second)
Input voltage is abnormal, too
high or too low
Check the adjustment of the
voltage of the battery pack
After power on, red LED always
lights, the motor doesn’t work
Throttle signal is abnormal Plug the receiver wire into the
throttle channel of the receiver
correctly
The motor runs in the opposite
direction when it is accelerated
The wire connections between
ESC and the motor are not
correct
Swap any two wire connections
between the ESC and the motor
The motor suddenly stops
running
The throttle signal is lost Check the transmitter and the
receiver
The ESC has entered the
“Low voltage protection mode”
or “Over-heat protection mode”
Red LED flashing means
“Low voltage protection”. Please
replace battery pack.
Green LED flashing means
“Over-heat protection”, please
stop running to cool the ESC.
When accelerating quickly, the
motor stops or trembles
1. The battery has a bad
discharge performance
Use a better battery
2. The “Start mode (Punch)” of
the ESC is too aggressive
Select a softer option for the
“Start mode (Punch)”
h. Trouble Shooting ESC Brushless