User manual

21
GB
CARSON Brushless Speed Controller Dragster 6S
d. Basic Settings
Throttle range setting
(throttle range calibration)
In order to make the ESC fit the throttle range
of your transmitter, you must calibrate it for the
following cases; otherwise the ESC cannot work
properly.
1) Begin to use a new ESC
2) Begin to use a new transmitter
3) Change the settings of neutral position of the
throttle lever, the ATV or EPA parameters, etc.
There need to be set 3 points. They are the end
point of “forward”, the end point of ”backward” and
the neutral point.
The following pictures show how to set the throttle
range with your transmitter.
A) Switch off the ESC and turn on the
transmitter.
B) Hold the “SETUP”-key of the ESC and then
switch on the ESC. Release the “SETUP” key
as soon as the red LED begins to flash.
Black power wire
(battery
negative)
Black power wire
(battery negative)
Red power wire
(battery positive)
ESC (+) red
ESC (-)
black
Red power wire
(battery positive)
ESC
black
ESC red
2 batteries connected in series
If you intend to connect
2 battery packs in series, please
use this schema: