Operating Guide

50
Tire Inspection Chart
^ WARNING
Worn, damaged or under-inated tires can
cause loss of control, injury and damage.
Check tires before each tow.
9.2.9 wheel BearIngS
A loose, worn or damaged wheel bearing is the most
common cause of brakes that grab.
To check your bearings, jack up the trailer and secure
it on adequate capacity jack stands. Check wheels for
side-to-side looseness.
If the wheels are loose, or spin with a wobble, the
bearings must be serviced or replaced.
^ WARNING
Never go under trailer unless it is on rm
and level ground and resting on properly
placed and secured jack stands.
If your axle(s) are equipped with a grease zerk on the
ends of the axle(s), the bearings must be greased
every 6 months or 6,000 miles to ensure reliable and
safe operation of your trailer.
1. Remove the rubber plug from the axle end.
2. Place grease gun on zerk.
3. Pump grease until new grease begins to appear.
Use a different color grease each time so you will
know when the new grease begins to appear.
4. Install rubber plug and cap. Repeat for remaining
wheel bearings.
If your trailer axle(s) are not equipped with grease
zerks, refer to the axle manufacturer’s manual for
service and maintenance information.
9.2.10 luBrIcatIon
Lubricate tilt deck pivots and hydraulic cylinder ends
every month (if equipped).
9.2.11 hydraulIc reSerVoIr
Check uid level prior to towing the trailer. The reservoir
is normally located inside the battery box.
The tilt deck must be fully lowered before checking uid
level. The reservoir should be lled to the full mark on
the side of the reservoir.
Use a quality hydraulic uid with anti-wear properties,
rust and oxidation inhibitors. Fluid ejecting from the
reservoir could indicate a low battery.
9.2.12 lug nutS or BoltS
Lug nuts or bolts are prone to loosen right after a wheel
is mounted to a hub. When driving on a remounted
wheel, check to see if the lug nuts or bolts are tight
after the rst 10, 25 and 50 miles of driving, and before
each tow thereafter.
^ WARNING
Inspection, Service And Maintenance