Specifications

CARROLL TOUCH Appendix B - Smart-Frame Protocol II Function Reference
Touch System Programmer’s Guide B-5
AttributeValue
= Indicates the value of the attribute. Values for
AttributeValue depend upon the value of the
corresponding AttributeTag. Refer to Table B-3 for the
possible values.
Table B-3. ComponentTypes, AttributeTags and AttributeValues
ComponentType AttributeTag AttributeValue
00 = Unknown.
01 = Sensor/Frame. 00 = Reserved.
01 = Touch Technology. Specifies the type of
touch technology that the sensor or frame uses
to detect touches.
00 = Unknown.
01 = Infrared.
02 = Guided Wave (default).
02 = Controller. 00 = Reserved.
01 = Touch Technology. Specifies the type of
touch technology that the sensor or frame that
this controller can control uses to detect
touches.
02 = Interface. Specifies the interface method
used by the controller.
03 = GW Dual Sensitivity. Specifies whether
the controller supports the dual sensitivity
feature, i.e., it supports two sensitivity
parameters, the Entry Sensitivity and Tracking
Sensitivity parameters, as opposed to one
sensitivity parameter, the Touch Sensitivity
parameter.
00 = Unknown.
01 = Infrared.
02 = Guided Wave (default).
00 = Unknown.
01 = RS-232 (default).
02 = Smart ISA Bus Controller
(HBC-style).
03 = Dumb ISA Bus Controller
(SBC-style).
00 = Dual sensitivity is not
supported (default).
01 = Dual sensitivity is supported.
03 = Processor. 00 = Reserved.
01 = Processor family. Specifies the type of
microprocessor used by the controller. Note
that the type of processor is not generally of
direct interest to software, but often serves to
help identify the exact controller being used.
00 = Unknown.
01 = DSP (320c26) (default).
02 = 805x (8051, 8052, etc...).
03 = 6805 (6805, 68705, ...).