Specifications

Appendix A - Smart-Frame Protocol Command Reference CARROLL TOUCH
A-34 Touch System Programmer’s Guide
Software_Reset (3CH) (<)
Command Description
The Software_Reset (3CH) command clears all touch system internal
buffers and resets the touch system parameters to the default conditions
as shown in Table A-4.
The Software_Reset (3CH) command is used to determine the parity
during the autobaud/autoparity sequence and must be followed by a
delay of at least 100 milliseconds to allow time for the initialization
sequence to finish if autobaud/autoparity is being used. It is
recommended, but not required, that a 100 millisecond delay be
included even if autobaud/autoparity is not being used.
See Also
Get_Error_Report (32H)
Table A-4. Touch System Default Settings
System Parameter Default Setting
Touch Scanning Off
Reporting Method Coordinate reporting
Touch Mode Tracking Mode
Add Exit Point Modifier Off
Report Transfer Off
Hardware Flow Control Off