Specifications

Appendix A - Smart-Frame Protocol Command Reference CARROLL TOUCH
A-18 Touch System Programmer’s Guide
* Error is cleared by sending the Software_Reset (3CH) command. All other error
codes, once detected, are reported for each subsequent error report.
Example
An example of an Error Report is:
F8 01 04 FF
It indicates that one “failed beam(s) detected” error was found.
See Also
Get_Configuration_Report (33H)
Get_Firmware_Version_Report (34H)
Software_Reset (3CH)
Run_Diagnostics (3AH)
12H -
18H
Reserved.
19H External Read Only memory (ROM) checksum verification error.
68705 Smart-Frame: N/A (No external ROM)
8031 Pre-modular separate controller (UFP III): Frame (EEPROM)
8031 Smart-Frame (SDSF): Frame (EEPROM)
Modular: Frame (EEPROM)
1AH
& up
Reserved.
Table A-3. Smart-Frame Protocol Error Report Error Codes (Con’t)
Error
Code
Description/Affected Touch System Component