Installation manual

7
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18
38AUQA25A0
C
6–0A0A0
Model Type Packaging
38AU= Carrier Condensing Unit
R--- 410A Refrigerant
0=Standard
Type of Coil
Electrical Options
Q = Heat Pump Scroll Compressor
A=None
C = Non-Fused Disconnect
1=LTL
Service Options
0=None
1=
Not Used
A=PlaceHolder
Base Unit Controls
0 = Electro-Mechanical Controls
Design Revision
Voltage
1 = 575/3/60
5 = 208 / 230/3/60
6 = 460/3/60
2 = Powered Convenience Outlet
Puronr
1 = Un-powered Convenience Outlet
_____________ ____
Nominal Tonnage
16 = 15 Tons
25 = 20 Tons
Refrigerant Options
A = None
B = Low Ambient
A = Initial Rev (Discrete Model Number)
Not Used
A=Not Used
Not Used
0=Not Used
M= Al/Cu with Hail Guard
N = Precoat Al/Cu with Hail Guard
P = E-Coat Al/Cu with Hail Guard
R = Cu/Cu with Hail Guard
Coil Options
A= Al/Cu
B = Precoat Al/Cu
C = E-Coat Al/Cu
E= Cu/Cu
C10676
Fig. 3 -- Model Number Nomenclature
SETANGISEDNOITISOP
)radnelac lacsif( erutcafunam fo keeW1−2
)ASU ,saxeT ,PTE = G( noitacol gnirutcafunaM5
rebmun laitneuqeS6−10
12345678910
4810G12345
POSITION NUMBER
TYPICAL
Year of manufacture (”10” = 2010)3−4
C10799
Fig. 4 -- Serial Number Nomenclature
.INSTALLATION
Jobsite Survey
Complete the following checks before installation.
1. Consult local building codes and the NEC (National
Electrical Code) ANSI/NFPA 70 for special installa-
tion requirements.
2. Determine unit location (from project plans) or select
unit location.
3. Check for possible overhead obstructions which may
interfere with unit lifting or rigging.
Step 1 — Plan for Unit Location
Select a location for the unit and its support system (pad,
rails or other) that provides for the minimum clearances
required for safety. This includes the clearance to
combustible surfaces, unit performance and service access
below, around and above unit as specified in unit
drawings. See Fig. 5.
Select a unit mounting system that provides adequate
height to allow for removal and disposal of frost and ice
that will form during the heating-defrost mode.
NOTE: Consider also the effect of adjacent units on
airflow performance and control box safety clearance.
38AUQ