Owner's Manual

Manual mapping of reference names

1 On the

Occupancy tab, click the zone you wish to configure in the Zone list.

2 Click

Microblocks in the Occupancy panel.

3 When the

Equipment panel appears, navigate the Equipment tree and select a microblock to associate.

4 Drag the selected microblock from the tree to the corresponding slot in the

Microblocks section.

NOTE To remove a microblock association, click the Delete ( ) button to the right of the microblock name.

Associating badge readers with a zone

Each zone can be assigned entrance badge readers to detect how many people have badged into a zone. Each

unique badge entry event increments the occupancy count for that zone. When the badge is detected in another

zone the occupancy count is decremented in the original zone and incremented in the new zone.

NOTES

• If no readers are configured under an OnGuard® device panel, the OnGuard® device panel will not show up

under

Peripheral Devices.

• A badge reader can only be mapped to a single zone. Readers that are already mapped will be grayed out

(disabled) in the

Peripheral Devices panel.

• Use the electrical drawing to determine which Access Control Devices belong to which zone.

To associate a badge reader

1 On the

Occupancy tab, click on the zone you wish to configure in the zone list.

2 Click

Associated Devices in the Occupancy panel.

3 When the

Peripheral Devices panel appears, select a reader to associate.

NOTE The items in the list are retrieved from the configuration of the connected OnGuard® system.

4 Drag the selected reader to the

Associated Devices section.

NOTE To remove a reader association, click the Delete ( ) button to the right of the reader name.