Instruction manual

2
INTRODUCTION
Carrier’s 7--day, 5/2--day, 1--day programmable and non--programmable
Performance Series Thermostat Control is a wall--mounted, low--voltage
temperature control in either a single unit or a two--piece unit. In two--piece
configuration, the relays are located near the equipment and a two--wire connection
is used between the Display Module and the Equipment Control Module.
Single--piece installation requires more wiring and results in a higher profile. The
Edget Thermostat has no need for batteries to store user--configured settings in
memory. During power loss its internal memory saves settings for unlimited time,
and the clock continues to run for at least 24 hours. An extension of Carrier’s
proven line of thermostats; it provides separate setpoints for heating and cooling.
In the Edge Thermostat Control programmable configuration, different heating and
cooling setpoints and times are programmable for 4 periods per day or 2 periods per
day. Programming can be done for 7 days per week, 5/2 days per week, or 1 day.
The programmable Thermostat Control can also be user configured as a
non--programmable Thermostat Control.
The non--programmable Thermostat Control features Touch ’N’ Got settings for
quick and easy temperature change without complicated programming schedules.
And, its Touch ’N’ Go technology enables the user to switch between three
different user--configurable settings through intuitive buttons located just below the
display.