Service manual

6-18T-294-01
1
2
3
4
5
6
5
7
8
9
1. Stator
2. Flat washer, 1/4
3. Bolt, 1/4-20 x 3/4
4. Locknut, 5/8-18
5. Flat washer, 5/8
6. Impeller Fan
7. Key
8. Mylar Protector
9. Evaporator Motor
Figure 6-20. Evaporator Fan Assembly
c. Assemble the Evaporator Fan Assembly
1. Assemble the motor and plastic spacer onto the
stator.
2. Apply loctite to the 1/4-20 x 3/4 long bolts and
torque to 0. 81 mkg (70 inch-pounds).
3. Placeone 5/8 flatwasher on theshoulder ofthefan
motor shaft. Insert the key in the keyway and
lubricate the fan motor shaft and threads with a
graphite-oil solution (such as Never-seez).
4. Install the fan onto the m otor shaft. Place one 5/8
flat washer with a 5/8-18 locknut onto the motor
shaft and torque to 40 foot-pounds.
5. Installthe evaporatorfanassemblyin reverseorder
of removal. Torque the four 1/4-20 clamp bolts to
0.81 mkg (70 inch-pounds) Apply power
momentarily to check for proper fan rotation (refer
to section 2.3). If fan spins backward, then motor
wiring or motor is defective.
6. Replace access panel making sure that panel does
notleak.MakesurethattheT.I.R.lockingdeviceis
lockwired.
6.17EVAPORATOR FAN MOTOR CAPACITORS
The evaporator fan motors are of the permanent-split
capacitor type. The motor is equipped with one
capacitor (used in the high speed circuit) and another
capacitor used for the low speed circuit.
a. When to check for a defective capacitor
1. Fan motor will not change speed. For example:
controller settings above --10_C(+14_F), or -- 5_C
(+23_F) optionally, should cause the motor to run in
high speed.
NOTE
The evaporator fan m otors will always start in
high speed.
Controller settings below --10_C(+14_F), or --5_C
(+23_F) optionally, should cause the motor to run in
low speed.
2. Motor running in wrong direction (after checking
for correct wiring application).
3. Motor not starting, and IP-EM’s are not tripping.
b. Removing the capacitor
WARNING
Make sure power to the unit is OFF and
power plug disconnected before removing
capacitor(s).
1. The capacitor located on the motor and above the
evaporator fan deck m ay be removed by t wo methods:
(a.) If container is empty, open upper rear panel of
the unit. The capacitor may be serviced after
disconnecting power plug.
(b.)Ifcontainerisfull,turntheunitpowerOFFand
disconnectpowerplug.Removetheevaporator
fan motor access panel. (See Figure 2-1). For
removaloftheevaporatorfanassembly,referto
section 6.16.
WARNING
With power OFF discharge the capacitor
and disconnect the circuit wiring.
c. Checking the capacitor
If the capacitor is suspected of malfunction, you may
choosetosimplyreplaceit.Directreplacementrequires
a capacitor of the same value. Two methods for
checking capacitor function are: