Service manual

v T -294-01
LIST OF ILLUSTRATIONS (CONTINUED)
Figure Page
Figure 3-1 Micro-Link 2i Controller/DataCORDER Module 3-1.....................
Figure 3-2 Key Pad 3-4......................................................
Figure 3-3 Display Module 3-5................................................
Figure 3-4 Standard Configuration Report Sample 3-33...........................
Figure 3-5 Controller Set Point BELOW --10_C(+14_F), or --5_C(+23_F) optionally 3-34.
Figure 3-6 Controller Set Point ABOVE --10_C(+14_F), or --5_C(+23_F) optionally 3-34
Figure 4-1 Cooling Mode 4-5.................................................
Figure 4-2 Heating Mode 4-7.................................................
Figure 4-3 Defrost Mode 4-9..................................................
Figure 6-1 Piercing Valve 6-1.................................................
Figure 6-2 Manifold Gauge Set 6-2............................................
Figure 6-3 R-134a Manifold Gauge Set Connection 6-3..........................
Figure 6-4 Refrigerant Recovery Process Tubes 6-5.............................
Figure 6-5 Vacuum Pump Connections 6-8.....................................
Figure 6-6 Compressor -- Model 06DR 6-9......................................
Figure 6-7 Exploded View of Valve Plate 6-10....................................
Figure 6-8 Bottom Plate Removed 6-10.........................................
Figure 6-9 Oil Pump and Bearing Head 6-11.....................................
Figure 6-10 Low Profile Oil Pump 6-11...........................................
Figure 6-11 Motor End Cover 6-12...............................................
Figure 6-12 Crankshaft Assembly 6-12...........................................
Figure 6-13 Removing Equalizing Tube and Lock Screw Assembly 6-12..............
Figure 6-14 Terminal Mounting Assembly 6-12....................................
Figure 6-15 Suction Valve & Positioning Springs 6-13..............................
Figure 6-16 Piston Rings 6-13...................................................
Figure 6-17 Compressor Oil Pump End View 6-14.................................
Figure 6-18 Typical Setup for Testing High Pressure Switch 6-16....................
Figure 6-19 Evaporator Fan Assembly 6-17.......................................
Figure 6-20 Supply Sensor Positioning 6-20......................................
Figure 6-21 Sensor (RRS, RTS, SRS or STS) 6-20................................
Figure 6-22 Sensor and Cable Assembly (RRS, RTS, SRS or STS) 6-20.............
Figure 6-23 Return Sensor Positioning 6-21......................................
Figure 6-24 Sensor (AMBS or DTS) 6-22.........................................
Figure 6-25 Sensor and Wire Assembly (AMBS or DTS) 6-22.......................