Technical data

96 | Status messages on the dispenser Operating manual ALX 73x | file version 00 | 03/2012
O PERATING FAULTS
ALX
73x
Status messages on the dispenser
Error messages
When an error occurs, the dispenser stops immediately and shows an error message
on the control panel.
Error messages are based on the following outline:
To delete an error message:
1. Rectify the cause of the fault. For further details see section
List of error mes-
sages 
on page 99.
2. Press the key to delete the message.
Error messages that are not described below can only be rectified by qualified service
personnel.
If an error that is not described here occurs:
1. Press the key to delete the message.
2. Switch off the device, wait for 30 seconds and switch it on again.
If the error occurs repeatedly:
 Call in a service technician.
Error messages not mentioned here are described in the service manual.
While an error message is being displayed, the "Error" signal output is active.
Warnings
Warnings refer to states less critical than error messages.
Labelling operation is not interrupted by a warning.
Warnings may occur in dispensing mode or in online settings mode.
Warnings are based on the following outline:
While a warning is being displayed, the "Warning" signal output is active.
Status num: 5144
a
Rewinder init
b
a) 5144 = The status number. This number is an easy
way to identify the message.
b) "Rewinder init" = Status text; brief description of the
error.
ONLINE
Material warning
a
a) "Material warning" = brief description depending on
what triggered the warning.