Technical data

68 | Inserting label material Operating manual ALX 73x | file version 05 | 03/2012

TARTUP

AND

OPERATION

ALX

73x

Threading the label web into the printer

1. Open the printer cover [50].



Hold the cover on the bottom right [50A].

2. Adjust the material guide to the width of the label

web. To do this, release the thumb screw [51A] on

the outer material guide [51B], push the material

guide up to the edge of the label material and screw

in the thumb screw again until it is tight.



The label material should move easily between

the guides.

3. Push the label material through the material guide

and up under the pressure roller.

4. Detach the pressure roller. To do this, rotate the

green lever [51C] in the direction of the arrow.

5. Push the material end under the printhead.

6. 2,5 Unroll the 2.5-m label web and remove the la-

bels from it.

7. Close the green lever [52].

Threading in the label web on the linear dancer

lever



Place the label web around the dancer lever; see

section

Threading diagrams on page 65.

[50] Open the printer cover.

[51] Adjust the material guide (B) for the width of the material.

[52] Shut the lever for the pressure roller.