Technical data

Operating manual ALX 73x | file version 01 | 03/2012 Printer parameter menu | 61
P RODUCT DESCRIPTION
ALX
73x
GB
SERVICE FUNCTIONS menu
Head dot test Checks the printhead for faulty dots. The check ends with a status report [38] contain-
ing a list of faulty dots. This printout is generated even if no faulty dots were found.
The following screen appears during the check:
 Required label material: 200 x 100 mm (length x width).
[38] Status report after the dot check has been successfully completed. Top section: Technical data for the
printhead; bottom section: faulty dots.
 The dot check can also be started in offline mode by pressing the cut (apply)+feed
keys. There is no status report in this case, however.
Print test A general print test; prints the set printer type and the number of the firmware version
in different fonts arranged by line with material settings such as material type, length
and width also taken into consideration.
 To exit the print test press the online key.
CAUTION!
Danger of damage to the printhead.
 Do not switch off the printer under any circumstances during the dot check! Failure
to observe this instruction may cause dots to be destroyed.
Head dot test
Please wait ...