Technical data

Operating manual ALX 73x | file version 01 | 03/2012 Printer parameter menu | 57

RODUCT

DESCRIPTION

ALX

73x

PRINT PARAMETERS menu

Print speed Print speed

The print speed (material feed) can be adapted to the combination of ribbon and ma-

terial in use to optimise the contrast intensity and the degree of blackening of the print

image.

Setting range: [2…16] inch/s; presetting: 8 inch/s

Feed speed Feed speed

The feed speed can be increased in areas with no print. This reduces the overall print

time, especially for long labels with very little printed surface.

 When the print speed is changed, the feed speed is set equal to the print speed. If

a different feed speed is preferred, it must be set again.

Setting range: [2…12] inch/s; presetting: 8 inch/s

Material type Definition of the label material in use.

Settings: [endless, punched]

• Endless: The label material has no punches or reflex markings. The start of the

label is calculated by the set label length (PRINT PARAMETERS > Material length).

• Punched: The individual labels in the label material that is used have punches or

reflex markings that can be detected by the label sensor.

 Only the "Punched" setting can be used for the ALX 73x.

Material length Label length, measured from the front (beginning) of a label to the front of the next la-

bel.

Setting range: [5…max. length

] mm; presetting: 100 mm

Material width Width of the label belt (including backing paper in the case of self-adhesive material).

Setting range: [Min. width

…Max. width

] mm; presetting: 100 mm

Print direction

[37] Alignment of the print image "Foot first" (A) or "Head first" (B).

1) "Max length": depends on the printhead width and memory configuration.

2) "Min. width": depends on the type of printer

3) "Max. width": depends on the printhead width and memory configuration of the printer

Printer

Printout