Technical data

54 | Dispenser parameter menu Operating manual ALX 73x | file version 02 | 03/2012

RODUCT

DESCRIPTION

ALX

73x

Disabled: Dispensing counter counts forwards, i.e. each label that is dispensed in-

creases the counter state.

Label stop quan. After dispensing this number of labels, the dispenser stops

This function only appears if LABEL SETUP > Stop count. mode = "Enabled"

Setting range: [0…99999]; default: 0

MACHINE SETUP menu

Store prod.prof. Save the current settings as a product profile

With the exception of functions MACHINE SETUP > Dispense counter and LABEL SETUP

> Label stop quan., all functions are saved as described under MACHINE SETUP > Store

Parameters = "Without adj. par" (file "Setup.for").

Del. prod.profil Deletion of a product profile from the internal database

Turn-on mode Operating mode the machine is in after it is turned on

Settings: [Online, Offline, Standalone]

• Online: dispensing mode

• Offline: setting mode

• Standalone: operation in standalone mode. Required to load firmware or configu-

rations from CF card.

Language Language used in the display

Settings: [German, English, French, Spanish, Dutch, Danish, Italian, Polish, Turkish]

Materialend err Related to internal OD monitoring.

• Settings: [Disabled, „Mat.diam < x mm“]

• Setting range for x = [40…500]

• Default setting: x= 60

Disabling the function:

 Set x < 40.

Re-enabling the function:

 Press the key.

Defines the diameter threshold for the material roll. If the (calculated) material roll di-

ameter is below the threshold value, the following status message appears:

An additional material end error is caused, if no unwinder rotation is detected during

at least 600 mm of material feeding:

Status num: 5071

Material end unw

Status num: 5072

Material end unw