Technical data
50 | Dispenser parameter menu Operating manual ALX 73x | file version 02 | 03/2012
P
RODUCT
DESCRIPTION
ALX
73x
Dispenser parameter menu
Overview of parameter menu
• Parameter with grey background:
Only the parameters required to operate a ALX 73x which has been configured
and set up are described in this operating manual. These parameters have a grey
background in the overview.
• Parameters with a white background:
Settings to parameters that are represented with a white background in
the overview require specialist knowledge and must therefore only be
made by qualified service personnel. These parameters are described in
the Assembly/Service manual.
LABEL SETUP MACHINE SETUP (continued) INTERFACE PARA (continued)
Load prod.profil Dispenser type Slave IP address >EASYPLUGINTERPR Port address
Gap detect. mode Store prod.prof. Tandem Distance Interface Ethernet speed
Dispense speed Del. prod.profil Label sens. type Spooler mode MAC Address
Slew speed Dispense counter Labelsen. InType Dispenser ID no. SNMP Agent
Label pitch Turn-on mode Startsen. In.Type Spooler size SNMP password
Lab. stop offset Language Start disp. mode Offline mode FTP server
Start offset Access authoriz. Start error stop Interface delay FTP Password
Product length Default values On inhibit enter WEB server
Multi label mode Factory settings On inhibit leave >COM1 PORT WEB admin passw.
Label 2 offset
a
Store Parameters Apply key Baud rate WEB supervisor p.
Label 3 offset
b
Loop dancer adj. Materialend err No. of data bits WEB operator p.
Miss. label tol. Auto Sensor Adj. Materialend warn Parity Time client
Miss. label mode Sensor Adjust
Rewinder full Stop bits Time server IP
Stop count. mode Speed Adaption Ext. OD sensor Data synch. Sync. interval
Label stop quan.
c
Encoder Type OD Sens.polarity Frame error DHCP host name
Encoder Resol. Loop supply mode
Encoder Diameter Loop setup >NETWORK PARAM.
Rewinder Operat. IP Addressassign
Rewinder gear IP address
Tandem Operation Net mask
Tandem synchron. Gateway address
[tab. 13] Menu overview - part 1.
a) Appears only if LABEL SETUP > Multi label mode = „x labels/start“.
b) Appears only if LABEL SETUP > Multi label mode = „3 labels/start“.
c) Appears only if LABEL SETUP > Stop count. mode = "Enabled".