Technical data

Operating manual ALX 73x | file version 00 | 03/2012 Reference status messages - printer | 105
O PERATING FAULTS
ALX
73x
GB
Reference status messages - printer
List of error messages
5001 No gap found
The label sensor has not found a label starting mark (punch or reflex marking).
 Incorrect setting of the material type.
 Check to ensure the setting of PRINT PARAMETERS > Material type matches the label
material you are using.
 Incorrect sensor type set (SYSTEM PARAMETER > Light sens. type).
 Check to ensure the set sensor type matches the label material (punches or reflex
markings).
 Incorrect label material inserted (material does not match the setting in PRINT PA-
RAMETERS > Material type)
 Check the label material.
 Incorrect position of label sensor.
 Check/correct position of label sensor.
 Material guide not set correctly - the label starting marks are running past to the
side of the label sensor.
 Check/correct the material guide setting.
 Label sensor is dirty.
 Clean the label sensor.
 The sensitivity of the label sensor is set too low. Materials with weak contrast be-
tween the material and backing paper or between the reflex marking and the material
require increased sensor sensitivity.
 Increase the sensitivity.
 Punch definition, material type and/or material length are specified incor-
rectly in the print job.
 Check the print job.
After confirmation with the online key, the material is automatically fed forward and the
system searches for the next punch.
5002 Material end
There is no more material in the material sensor.
 Label roll is used up.
 Insert a new label roll.
 Material guide not set correctly - the label starting marks are running past to the
side of the label sensor.
 Check/correct the material guide setting.
5003 Cover open
 The front cover of the printer is open.
 Close the front cover.
Closing the front cover automatically deletes the error message.