Technical data

Operating manual ALX 73x | file version 01 | 03/2012 Reference status messages - dispenser | 101
O PERATING FAULTS
ALX
73x
GB
5070 LDU upper limit
The linear dancer lever has reached the upper limit stop. This causes the printer to
stop.
 The material ribbon is torn.
 Insert new label material.
 If this error occurs repeatedly reduce the spring tension of the linear dancer arm.
 Linear dancer lever sensor is not connected.
 Check the sensor cable.
 Sensor cable of the linear dancer lever sensor is faulty.
 Replace sensor cable.
5140 Rewinder control
During problem-free operation the rewinder dancer lever moves only minimally
around the "control position". This is the position the dancer lever assumes after
the machine is initialised.
 The dancer lever is moved by the effect of a force from outside the control position.
 Press the key.
The dancer lever controller is then reinitialised. The dancer lever moves back to the
control position.
Example: feed motor blocked; the backing paper is not moved quickly enough; this
causes the dancer lever to be drawn upward.
Example: tearing of the backing paper; the dancer lever moves back down by spring
force.
5143 Rewinder stop
The rewinder dancer lever is no longer able to move. Therefore the rewinder motor is
switched to a powerless state.
This can be selectively used to insert a new label roll because the rewinder can
easily be turned when the motor is switched off.
 The dancer lever was held at the upper limit stop for longer than two seconds.
 Press the key to confirm the error message.
5145 Rewinder full
 The maximum permissible diameter of the rewinder roll has been reached.
 Remove wound backing paper
 Press the key to confirm the error message.
This error can only occur if the end of a new label roll has been pasted onto a
backing paper that is already wound around the rewinder.