Technical data

100 | Reference status messages - dispenser Operating manual ALX 73x | file version 01 | 03/2012
O PERATING FAULTS
ALX
73x
5026 MotorProtect CPU
 Dust filter fleece dirty. This will cause the machine to overheat.
 Replace the dust filter fleece. Allow the machine to cool off.
 Connector cable between CPU board and motor driver board not connected or
faulty.
 Check whether the cable is connected correctly.
 Check the cable.
 Motor driver board overheated or faulty
 Switch off the machine, wait for 30 seconds and switch it on again.
If the error message occurs repeatedly:
 Replace the motor driver board.
5065 OD Material end
 Occurs in operation with the external OD sensor activated.
The critical material roll diameter has been reached. The label material will soon be
gone.
 Prepare to insert a new material roll
5067 L. DancArmSens
Linear dancer lever sensor
Bad connection to the dancer lever sensor.
 Sensor cable is not connected.
 Connect the sensor cable.
 Sensor cable is faulty.
 Check the sensor cable and if necessary replace it.
5068 Int. mod. synch
Communication between printer and dispenser has been interrupted.
 The printer is switched off.
 Switch on printer
 The connector cable between printer and dispenser is damaged or not connected.
 (Service) check connector cable between printer and dispenser.
5069 LDU lower limit
The linear dancer lever has reached the lower limit stop.
 Dispensing speed and/or dispensing rate are too high relative to the print speed.
 Increase the print speed
 Reduce dispensing speed
 Reduce the dispensing rate (number of labels dispensed per unit of time)
 Linear dancer lever sensor is not connected.
 Check the sensor cable.
 Sensor cable of the linear dancer lever sensor is faulty.
 Replace sensor cable.