Technical data

Operating manual ALX 73x | file version 01 | 03/2012 Reference status messages - dispenser | 99
O PERATING FAULTS
ALX
73x
GB
Module speed  The printer is printing too slowly. Start signals must therefore be left out.
 Increase the print speed or reduce the dispensing speed/dispensing rate.
Foil low  Critical foil roll diameter at the printer reached.
 Prepare for foil roll change
List of error messages
5000 Bus device
This message appears in most cases as the first of a series of two or three mes-
sages that more closely limit the source of the error.
 Unable to access device on the I
2
C bus.
 Delete the message after pressing the key.
 Switch off the machine, wait for 30 seconds and switch it on again.
 If the error message occurs repeatedly, call in a service technicians.
5001 No gap found
No punches were found
The label sensor has not found any label gap or punch.
 Material end (if no roll diameter sensor is activated).
 Insert material.
 The limit value for missing labels has been exceeded (LABEL SETUP > Miss. label tol.).
 Check the label material.
 Label type is not set correctly (MACHINE SETUP > Sensor type).
 Check/change setting.
 The label length is not set correctly (LABEL SETUP > Label pitch).
 Check/change setting.
 Label sensor is dirty.
 Clean the label sensor.
 Label sensor is not in the correct position.
 Check/change the position of the label sensor.
 Label sensor is not correctly connected.
 Check whether the label sensor is plugged into the correct connection.
 Label sensor is faulty.
 Replace the label sensor.
 Rotary encoder is not correctly connected.
 Check/change the rotary encoder settings.
 In all cases: Press the key to confirm the error message.
5002 Material end
 Material end (when the intern OD sensor is connected and activated).
 Insert a new label roll.
 Internal OD sensor is not connected, but is activated.
 To deactivate the internal OD sensor: MACHINE STATUS > Material end err = "Off".