Technical data

98 | Reference status messages - dispenser Operating manual ALX 73x | file version 01 | 03/2012
O PERATING FAULTS
ALX
73x
Reference status messages - dispenser
List of warnings
Rew. stop warn  The material rewinder was switched off by the operator.
 After removal of the rewound backing paper, switch the material unwinder on
again.
Productstartwarn  New start signal during the dispensing cycle. The contour of the product is resulting
in multiple start signals.
 Activate LABEL SETUP > Product length.
 Several missing labels on the label belt; unable to compensate for the gap.
 Check the label material.
PMA warning  The printer (PMA) has stopped or an error has occurred on the printer.
 Check the printer.
Material low  (Internal OD sensor) critical material roll diameter reached.
 Prepare for material change
APSF speed warn.  The speed of the conveyor belt has exceeded the maximum speed of the
dispenser.
 Reduce the speed of the conveyor belt.
OD sensor warn.  (External OD sensor) critical material roll diameter reached.
 Prepare for material change
Toomany products  Each product triggers more than one start signal.
 Activate LABEL SETUP > Product length.
 Verify, if there are other causes which trigger start signals (e.g. reflections). If yes,
eliminate those causes.
 Too many products are between product sensor and dispensing edge (>64). The
buffer for product start signals is about to overflow.
 Move the product sensor closer to the dispensing edge.
 The resolution of the rotary encoder is set wrong.
 Verify, if the conveyor speed matches the speed which is displayed on the operator
panel. If not, correct the resolution setting of the rotary encoder.
Int. mod. synch  Although communication between printer and dispenser has been interrupted,
labels can currently still be dispensed from the buffer loop.
 Check the connection line; see status message 5068  on page 100.