Specifications

5
10. Secure the air conditioner to the bottom of the
window sash with one
3
/
4
-in. screw provided.
Screw is installed through the hole in the center of
the top channel of the air conditioner. See Fig. 8.
11. Pull out the expanding side shutters from the
sides of the air conditioner. The panels should
expand to cover the entire width of the window.
There is a hole provided in the top end of each side
shutter which is used to secure the panels to the
window. There is a tab on the bottom of the side
shutter provided to secure the side shutter to the
window sill. With the wing panels expanded,
mark the drilling locations on the sides of the win-
dow frame and sill (through the holes in the pan-
els). See Fig. 8.
12. Drill the holes marked in Step 11 with
1
/
8
-in. drill
bit. With the wing panels expanded, secure the
wing panels with two
3
/
4
-in. screws provided (each
side). See Fig. 8.
13. Cut thick foam seal (provided) to fit the length of
the window. Insert the foam seal between the top
of the lower window sash and the window panes of
the upper window. See Fig. 8. Make sure there is
a firm fit to prevent air leakage between the win-
dows. This also prevents insects from entering
through the window.
14. Plug in the unit.
SEAL
CENTER LINE
7.5
7.5
OUTER SILL
INNER SILL
3/4"
SCREW
CENTER LINE
3/4"
SCREW
BRACKET
SHORT SIDE
SEAL
L BRACKET
FIGURE 4 — FOAM SEAL INSTALLATION
FIGURE 5 — DETERMINE CENTER OF SILL
FIGURE 6 — L-BRACKET INSTALLATION
FIGURE 7 — AIR CONDITIONER
INSTALLATION LOCATION
FOAM
3/4"
SCREW
3/4" SCREW
3/4" SCREW
3/4" SCREW
3/8" SCREW
FIGURE 8 — SECURE AIR CONDITIONER
TO WINDOW