Specifications

VIRTU

SECTION 1 – Communication Planning

C ONNEXUS™

58 | CANADA CONFERENCE

ELECTRICAL CORD LENGTHS

Connexus™ modules come with pre-determined electrical cord lengths that are suited to the size and

conﬁguration of each table (6’, 16’, 25’). Each will plug into a standard ﬂoor monument power source.

However, in situations where a table length exceeds our maximum cord length, a second power entry is

necessary to avoid daisy-chaining of electrical power. To determine when a second power entry is

required follow these steps:

1. Select your Connexus™ locations.

2. Select your Floor Monument Location(s) if they do not already exist in the room.

3. If the number of Connexus™ modules exceed three consecutive positions left or right of the power

entry, then an additional power entry will be required. Refer to the Connexus™ diagrams on

pages 123-134 that illustrate the base and tabletop combination of your selection.

Note: Connexus™ modules in pairs count as one position.

* Open Visio tables require 2 power sources, one per wing, or a single power source located at the

apex of the two tables.

Example 1

If the designated Floor Monument location for the table scenario shown below is 1L, the user

would be able to power-up any or all of the following Connexus™ locations: AL, BL, and CL.

Example 2

If the designated Floor Monument location for the table scenario shown below is 2R, the user

would be able to power-up any or all of the following Connexus™ locations: CL, CR, BR and

AR.

Monument Location Scenario Connexus™ Location Scenario

1L 2L 3L 3 3R 2R 1R

ACW3 FCE3DCE3 ECE3CCW3BCW3

EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST