Specifications

34 | CANADA CONFERENCE
MILLENNIUM CONNEXUS™ LOCATIONS CHARTS
REPRESENTS MODULES THAT WHEN
OPENED FACE THE ENDS OF THE TABLE
REPRESENTS MODULES THAT WHEN
OPENED FACE THE SIDES OF THE TABLE
T OP S TYLES B ASE S TYLES
Square
Round
Round Drum
Base
The Connexus™ Locations diagrams below show the available Connexus™ locations for only the top and base configurations shown above.
Please note that the maximum allowable Connexus™ modules per top are shown, and tops may be specified with fewer modules.
Each Connexus™ module has a code to represent its location on the table surface. To specify a Connexus™ module in a particular
location, please use the code listed above it. For specific pricing on individual Connexus™ modules please see pages 30-33.
Note: One Connexus™ module is available where two modules are shown. Please refer to location code above the drawing for single
centre location in which case the Connexus™ unit will face West if on the left end of the top, and East if on the right end of the top.
For large Connexus™ units please replace “3” in location code with “4”. Please see conditions at bottom of page.
Connexus™ is not available on 36” square or round tops.
18” Drum bases will accommodate single standard Connexus™ units only.
24” Drum bases will accommodate single standard or large Connexus™ units only.
30” Drum bases will accommodate single or double standard or
large Connexus™ units.
Represents 42” and 48” top locations Represents 42”,48” and 54” top locations
ACN3 ACN3
Represents 60” top locations Represents 60” top location
ACN3 ACN3
ATN3 ATN3
ABS3 ABS3
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST