Specifications

CONNEXUS™
Connexus™ is Krug’s proprietary tabletop connectivity solution. When opened, it presents power and data outlets on a convenient
angle to the user and provides storage for wiring.
The faceplate of Connexus™ is available in either Glass or Aluminum and sits
ush with the tabletop. It is designed to allow wiring to
pass through the surface cover in both the open and closed positions. The faceplate opens to a 100˚ angle from the table top.
Connexus™ utilizes UL standard receptacle outlets. Connexus™ offers 11 pre-con
gured units with a wide selection of power, data
and presentation system outlets, or alternatively can be purchased with just electrical ports with blank data ports. Connexus™ also
can be designed and built speci
cally to meet your connectivity needs by using the snap-in or plate mounted port options.
All corded units can be modi
ed to allow the units to be hard wired by an electrician and data ports can be recon gured easily when
desired. To facilitate this process, the Enclosure Box of each Connexus™ module is easily removable.
*All duplex outlets are contained within a metal box that is attached to the Partition Plate. If additional outlets need to be added in the
future, these boxes need to be ordered from Krug to expand the enclosure. All modi
cations must be done by a quali ed electrician.
The label drawing shown below illustrates the way a Connexus™ module is shipped to the user. The Partition Plate is mounted on-site
to the underside of the top with the Enclosure Box over top to conceal the module. Please note, enclosure boxes are not required when
modules are enclosed in a base. Enclosure boxes are not supplied with Connexus™ modules; they must be ordered separately when
re
quired.
Connexus™ Faceplate
Decora Faceplate
Electrical/Data Outlets
Partition Plate
Enclosure Box
Standard Connexus™ Components Blank Connexus™ ModuleStandard Connexus™ Module
L
Connexus™ modules may be speci ed in Standard or Large sizes.
Standard modules are available in 7 standard con
gurations or
custom con
gurations. Connexus™ modules in Standard con gurations
are 6 1/8" x 7 3/8". Depth on Standard module is 4.5".
Large modules are available.in 4 standard con
gurations or custom
con
gurations. Connexus™ modules in Large con gurations are
8 1/4" x 7 3/8". Depth on Large module is 4.5".
Standard - 3 Gang Large - 4 Gang
Connexus™ modules are wired independently of each other to maximize the amount of electrical devices serviced. All Connexus™
modules may sustain individual loads of 15 amps or 12 amps of continuous load. Each Connexus™ module will require a single isolated
circuit to maximize its service capabilities. An optional utility a/c power outlet is available on the back surface of the outlet box.
Connexus™ components are UL and CSA US approved and manufactured in accordance to the National Electrical Code. Hardwiring
Connexus™ modules on-site must be performed by a licensed electrician. Connexus™ units can be ordered with an optional utility
outlet, which is located on the bottom side of the Connexus™ unit and underneath the work surface. Other Connexus™ products could
employ these utility outlets as a source of power. In this scenario, it is solely the responsibility of the end user to assure that proper
circuit protection is in place that never exceeds the 15 Ampere Circuit Breaker Rating.
CONNEXUS™ FIELD TABLE CUT-OUT KIT ( ONLY REQUIRED FOR INSTALLATIONS AFTER TABLE PURCHASE)
3 Gang CONFIELD3 $300
4 Gang CONFIELD4 $300
*
CONNEXUS™ SIZES
CONNEXUS™ | PLANNING
i | Virtu Conference | CONNEXUS™