Specifications

VIRTU
SECTION 3 – Installation Instructions
I NSTALLATION I NSTRUCTIONS
CONFERENCE CANADA | 197
ox
LEFT
RIGHT
GROUND
On site electrical outlet wire schematic
1. Power supply
2. Strain relief
3. Fork terminal
4. Duplex receptacles
5. Outlet with breaker assembly
6. Handy box
On site RCA cable hookup
1. Determine the correct length of cord (RCA cable is not
supplied).
2. Attach appropriate end of cable to the back of Connexus
interface connector.
3. Route cable through appropriate wire management.
On site BNC cable hookup
1. Determine the correct length of cord (BNC cable is not
supplied).
2. Attach appropriate end of cable to the back of Connexus
interface connector.
3. Route cable through appropriate wire management.
On site 15 PIN HD cable hookup
1. Determine the correct length of cord (VGA cable is not
supplied).
2. Attach appropriate end of cable to the back of Connexus
interface connector. Tighten fasteners if equipped.
3. Route cable through appropriate wire management.
On site DB-9 cable hookup
1. Determine the correct length of cord (Serial cable is not
supplied).
2. Attach appropriate end of cable to the back of Connexus
interface connector. Tighten fasteners if equipped.
3. Route cable through appropriate wire management.
On site MINI STEREO wiring hookup
1. Determine the correct length of cord (shielded 2 conductor
cable is not supplied).
2. Remove about 1” of the wire jacket and about 1⁄4” of
insulation from each wire.
3. Insert wire into terminal block and tighten with a 3/32” flat
screw driver. See Fig. 1.
4. Route cable through appropriate wire management.
1
5
GREEN
BLACK
BLACK
WHITE
WHITE
BLACK
WHITE
BOX GROUND
CIRCUIT BREAKER/OUTLETS ASSEMBLY
WHITE DECORA DUPLEX
WIRING DIAGRAM
''12// AWG
BLACK WIRE - BRASS SCREW\
WHITE WIRE - SILVER SCREW
GREEN WIRE - GREEN SCREW
REMOVE 4 PLASTER EARS
4
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST