Specifications

VIRTU
SECTION 3 – Installation Instructions
I NSTALLATION I NSTRUCTIONS
196 | CANADA CONFERENCE
On site RJ11 wire instructions
Voice grade Snap-In Connector Installation Instructions
SAFETY INFORMATION
1. Never install communications wiring or components during a lightning storm.
2. Never install communications components in wet locations unless the components are designed specifically for use
in wet locations.
3. Never touch uninsulated wires or terminals unless the wiring has been disconnected at the network interface.
4. Use caution when installing or modifying communications wiring or components.
5. To prevent electrical shock, each opening must be filled with a module or blank filler.
IMPORTANT INSTRUCTIONS
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Do not use this product near water—e.g., near a tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or
near a swimming pool.
4. Never push objects of any kind into this product through cabinet slots, as they may touch dangerous voltages.
SAVE THESE INSTRUCTIONS.
1. Remove connector from Connexus interface panel by inserting a small flat screw into top of connector/ faceplate and
twist slightly. Connector should pop out.
2. Remove jacket from cable.
3. Check jack termination label (located on sides of jack) for wiring standard and associated colour codes. The label also
includes jack pin numbers. (Figure 1)
4. Route the wires for termination as shown in Figure 2.
5. Using a 110 style punchdown tool (not supplied), seat the wires into the IDC slots. With the cutting edge of the tool
to the outside, trim the excess wire flush with the jack body. (Figure 3)
6. Place the cap over the termination wires for secure connection and added strain relief. (Figure 4)
7. Insert connector assembly into Connexus interface. Note the “UP” position of the connector.
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST