Specifications

VIRTU
SECTION 3 – Installation Instructions
I NSTALLATION I NSTUCTIONS
192 | CANADA CONFERENCE
4. Assemble the tite-joint fastener as shown in figure 1. Install assembled tite-joint with machining
in table sections.
correctly installed incorrectly installed
5. Flush the edge of the sections and tighten fasteners with rod provided (C). Do not over tighten
6. As shown in Figure 2, align holes in the channel brackets (D) with threaded inserts in the top sections.
To fasten the channel brackets, start threading the 3/4" bolts (A) by hand. This will prevent cross-
threading the bolt into the inserts, which may cause damage to the table tops.
7. Put bases in the approximate place where the table will be located in the room. Flip all assembled table
sections over and place over bases. Repeat steps 4-6 (if required) for sections not already attached.
A
D
Figure 2
cut outs face towards
centre of table
door faces towards
centre of table
Figure 1
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST