Specifications

VIRTU
SECTION 3 – Installation Instructions
I NSTALLATION I NSTUCTIONS
CONFERENCE CANADA | 189
4. Assemble the tite-joint fastener as shown in figure 1. Install assembled tite-joint with machining in table
sections.
correctly installed incorrectly installed
5. Flush the edge of the sections and tighten fasteners with rod provided (C). Do not over tighten
6. As shown in Figure 2, align holes in the channel brackets (D) with threaded inserts in the top sections.
To fasten the channel brackets, start threading the 3/4" bolts (A) by hand. This will prevent cross-
threading the bolt into the inserts, which may cause damage to the table tops.
7. As shown in Figure 3, invert and position the bases onto the underside of the outer table sections and
align the metal base plates with the inserts in the underside of the top. To fasten bases to the top, insert
the 3/4" bolts (A) through the plate on the base and into the inserts. Start threading the bolts by hand
to prevent cross-threading. Tighten with allen key or power driver.
A
D
Figure 1
Figure 2
Figure 3
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST