Specifications

VIRTU
SECTION 3 – Installation Instructions
I NSTALLATION I NSTUCTIONS
CONFERENCE CANADA | 187
Single Section with Forza Legs or Panels
C
OMPONENTS T OOLS R EQUIRED
3/4" Hex drive bolt (112164) 5/32" Allen Key or driver
• 6 per leg/12 per panel
IMPORTANT: If table has Connexus™ modules, install them using their instructions before proceeding.
P ROCEDURE
1. Unpack table and all bases. Find all the hardware listed. Fasteners are in a bag on the bottom of one
section (some fasteners may be shipped with the bases.) MAKE SURE THE CORRECT SIZE AND
QUANTITY OF COMPONENTS ARE INCLUDED WITH THE TABLE.
2. Place table upside down onto a soft surface. As shown in Figure 1, invert and position the bases onto
the underside of the table and align the metal base plates with the inserts in the underside of the top.
THE BLACK PLASTIC EXTRUSION FACES TOWARDS THE CENTRE OF THE TABLE.
3. To fasten bases to the top, insert the 3/4" bolts through the plate on the base and into the inserts.
Start threading the bolts by hand to prevent cross-threading. Tighten with allen key or power driver.
4. Flip assembled table over.
5. Attach wire management components to bottom of assembled table.
For additional help please contact Customer Service.
CAUTION:
TABLES CAN BE EXTREMELY HEAVY. MAKE SURE THERE ARE SUFFICIENT
PEOPLE AVAILABLE TO FLIP TABLE UPRIGHT. DO NOT SUBSTITUTE
HARDWARE. IF HARDWARE IS MISSING, CONTACT CUSTOMER SERVICE.
Figure 1
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST