Specifications

VIRTU
SECTION 3 – Installation Instructions
I NSTALLATION I NSTUCTIONS
186 | CANADA CONFERENCE
7. Stand centre section upright and attach to appropriate side of single end section. Insert the 3/4" bolts (A)
through the plate on the base and into the inserts. Start threading the bolts by hand to prevent cross-
threading. Tighten with allen key or power driver.
8. Repeat steps 5-7 for double end sections.
9. Assemble the tite-joint fastener as shown in figure 3. Install assembled tite-joint with machining in table
sections.
correctly installed incorrectly installed
10. Flush the edge of the sections and tighten fasteners with rod provided (C). Do not over tighten.
11. Adjust top alignment, if required by slightly loosening tite-joint fasteners and base plate bolts, making the
adjustment and re-tightening fasteners and bolts.
12. Attach modesty panels with L-brackets and screws provided.
13. Attach wire management extrusion to modesty panels with screws provided.
For additional help please contact Customer Service.
CAUTION:
TABLES CAN BE EXTREMELY HEAVY. MAKE SURE THERE ARE SUFFICIENT
PEOPLE AVAILABLE TO FLIP TABLE UPRIGHT. DO NOT SUBSTITUTE
HARDWARE. IF HARDWARE IS MISSING, CONTACT CUSTOMER SERVICE.
Figure 3
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST