Specifications

VIRTU
SECTION 3 – Installation Instructions
I NSTALLATION I NSTUCTIONS
184 | CANADA CONFERENCE
Single Section with Dais, Forza Square & Oblique
C
OMPONENTS T OOLS R EQUIRED
3/4" Hex drive bolt (112164) 5/32" Allen Key or driver
• 8 per Dais/Oblique base
• 12 per Verso/Forza Square base
IMPORTANT: If table has Connexus
TM
modules, install them using their instructions before proceeding.
P ROCEDURE
1. Unpack table and all base(s). Find all of the hardware listed. Fasteners are in a bag on the bottom of
one section (some fasteners may be shipped with the bases).
MAKE SURE THE CORRECT SIZE AND QUANTITY OF COMPONENTS ARE INCLUDED WITH
THE TABLE.
2. Put base(s) in the approximate place where the table will be located in the room. Place over base(s).
Align the metal base plates with the inserts in the underside of the top.
3. To fasten bases to the top, insert the 3/4" bolts through the plate on the base and into the inserts.
Start threading the bolts by hand to prevent cross-threading. Tighten with Allen key or power driver.
Forza Dais Oblique
4. Attach wire management components to bottom of assembled table.
For additional help please contact Customer Service.
CAUTION:
TABLES CAN BE EXTREMELY HEAVY. MAKE SURE THERE ARE SUFFICIENT
PEOPLE AVAILABLE TO FLIP TABLE UPRIGHT. DO NOT SUBSTITUTE
HARDWARE. IF HARDWARE IS MISSING, CONTACT CUSTOMER SERVICE.
cut outs face towards
centre of table
door faces towards
centre of table
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST