Specifications

VIRTU

SECTION 2 – Ordering and Pricing

F LOOR M ONUMENT L OCATIONS

CONFERENCE CANADA | 137

Electrical Cord Lengths

Connexus™ Modules come with pre-determined electrical cord lengths that are suited to the

size and conﬁguration of each table. Each will plug into a standard ﬂoor monument power

source. However, in situations where a table length exceeds our maximum cord length, a second

power entry is necessary to avoid daisy-chaining of electrical power. To determine when a

second power entry is required please follow these steps.

1. Select your Connexus™ Location(s).

2. Select your Floor Monument Location(s) if they do not already exist in the room.

3. If the number of Connexus™ Modules exceed three consecutive positions left or right of

the power entry, then an additional power entry will be required. Refer to the

Connexus™ Diagrams on pages 123-134 that illustrates the base and tabletop

combination of your selection.

Note: Connexus™ Modules in pairs count as one position.

* Open Visio tables require 2 power sources, one per wing, or a single power source located at

the apex of the two tables.

Example 1

If the designated Floor Monument location for the table scenario shown below is 1L, the user

would be able to power-up any or all of the following Connexus™ locations: ACW3, BCW3

and CCW3.

Example 2

If the designated Floor Monument location for the table scenario shown below is 2R, the user

would be able to power-up any or all of the following Connexus™ locations: CCW3, DCE3,

ECE3 and FCE3.

Monument Location Scenario Connexus™ Location Scenario

1L 2L 3L 3 3R 2R 1R

ACW3 FCE3DCE3 ECE3CCW3BCW3

EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST