Specifications

VIRTU
SECTION 2 – Ordering and Pricing
C ONNEXUS™LOCATIONS C HARTS
REPRESENTS MODULES THAT
WHEN OPENED FACE THE ENDS
OF THE TABLE
REPRESENTS MODULES THAT
WHEN OPENED FACE THE SIDES
OF THE TABLE
130 | CANADA CONFERENCE
ACW3
BCW3
CCE3
ACW3
CCE3
BKW3
ACW3
DCE3
BMW3
120"
144"
168"
The Connexus™ Locations diagrams below show the available Connexus™ locations for only the top and base configurations shown
above. Please note that the maximum allowable Connexus™ modules per top
are shown, and tops may be specified with fewer
modules. Each Connexus™ module has a code to represent its location on the table surface. To specify a Connexus™ module in a
particular location, please use the code listed above it. Note that Large Connexus™ modules can only be specified on the outside
sections of tops. For specific pricing on individual Connexus™ modules please see pages 118-122. Connexus™ locations and
quantities may be limited if Floor Monuments already exist at installation site. Please see Floor Monuments section (pg 135)
for more information. For large Connexus™ units, please replace “3” in location code with “4”. Codes that appear above
table illustrations represent single centre locations, in which unit will face West if on left end of top, and East if on right end
of top. Note: For Connexus™ locations other than those shown below, contact Customer Service for upcharge.
216"
240"
T OP S TYLES B ASE S TYLES
Visio
Dais
Forza Square
Oblique
192"
ACW3
CCE3
BCW3
DCE3
ACW3
CCW3
BCW3
ECE3
DCE3
ACW3
CCW3
BCW3
ECE3
DCE3
EFFECTIVE MARCH 1, 2008 A PRICE INCREASE OF 5% WILL APPLY TO ALL PRODUCTS IN THIS PRICE LIST