Product data

5
A00358
DIMENSIONS (In.)
* Refer to the furnace Installation Instructions for proper venting procedures.
UNIT
SIZE A D
E
VENT
CONNECTION*
MEDIA
CABINET
SUPPLIED
060-12 14-3/16 12-9/16 12-11/16 4 16''
080-16 21 19-3/8 19-1/2 4 20''
100-20 24-1/2 22-7/8 23 4 24''
120-20 24-1/2 22-7/8 23 5 24''
A
D
13⁄16˝
E
11⁄16˝
11⁄16˝
28 1⁄2˝
39 7⁄8˝
24 5⁄16˝
11⁄16˝
3˝
2 1⁄16˝
1˝
12 5⁄16˝
5 3⁄8˝
5 13⁄16˝
2 3⁄8˝
AIR INLET
7⁄8-IN. DIA HOLE
POWER ENTRY
7⁄8-IN. DIA
ACCESSORY
1 3⁄4-IN. DIA HOLE
GAS ENTRY
1⁄2-IN. DIA HOLE
THERMOSTAT
WIRE ENTRY
VENT CONN
1. Two additional 7⁄8-in. dia holes are located in the top plate.
2. Minimum return-air openings at furnace, based on metal duct. If flex duct is used,
see flex duct manufacturer's recommendations for equivalent diameters.
a. For 800 CFM–16-in. round or 14
1⁄2 x 12-in. rectangle.
b. For 1200 CFM–20-in. round or 14
1⁄2 x 191⁄2-in. rectangle.
c. For 1600 CFM–22-in. round or 14
1⁄2 x 231⁄4-in. rectangle.
d. For airflow requirements above 1800 CFM, see Air Delivery table in Product Data literature for specific
use of single side inlets. The use of both side inlets, a combination of 1 side and the bottom, or the
bottom only will ensure adequate return air openings for airflow requirements above 1800 CFM.
NOTES:
5 3⁄8˝
5 13⁄16˝
2 3⁄8˝
2 11⁄16˝
1˝
2 1⁄16˝
19˝
13⁄16˝
7⁄8-IN. DIA
POWER ENTRY
AIRFLOW
OUTLET
1 1⁄2-IN. DIA
R.H. GAS ENTRY
7⁄8-IN. DIA ACCESSORY
1⁄2-IN. DIA THERMOSTAT
WIRE ENTRY
SIDE INLET (FOR UPFLOW
INSTALLATION ONLY)
141⁄2˝
1˝
231⁄4˝
SIDE RETURN
DUCT LOCATION
1
1⁄4˝
TYP 1˝
5⁄8˝
TYP
SIDE INLET (FOR UPFLOW
INSTALLATION ONLY)
DIMPLES TO DRILL HOLES FOR HANGER BOLTS:
8 PLACES (FOR HORIZONTAL INSTALLATIONS ONLY)
A99273