Specifications

CAUTION
The heating element in the
evaporator pan is very hot when
on.
HIGH
PRESSURE
In store service is limited and can be completed in just
a few minutes each week.
Make sure that both switches are tuned OFF before 1.
starting to service the case. They are located just
behind the upper access door.
Unplug both the sump pump and the evaporator 2.
heater pan from the duplex plug.
Use the following specialty cleaning products for dif-
cult stains that may appear:
Armor All© for polymer parts •
3M brand© Stainless Steel Cleaner and Polish •
3M brand© Troubleshooter Cleaner•
3M brand© Sharpshooter, Extra Strength No •
Rinse Cleaner
Revere© aluminum powder for tank liner•
Remove the condenser lter element from the 3.
holder and replace it with a new one (P071083A)
While the lter is 4.
removed check
to see if the ns
on the condenser
are clean. If not,
using care, a shop
vacuum and a soft
brush attachment
clean any dirt or
dust from the ns.
DO NOT bend 5.
any ns during
lter change or
cleaning op-
eration. The case
performance WILL
BE REDUCED.
Before cleaning the evaporator pan ensure that it 6.
has been unplugged, and allow to cool. Wipe the
inside of the evaporator pan to remove residue and
any debris that may have fallen into the chamber.
Ensure that the oat can move freely.7.
Plug back in the Sump Pump and evaporator 8.
heater.
Turn on both switches, located just behind the up-9.
per access door.
P071253M SERVICE REV 0
3
FILTER CHANGING
CLEANING PRODUCTS
If you have any questions or concerns, please contact Hill
PHOENIX at 1-800-283-1109 (select extension “2444”).
QUESTIONS?
IN- STORE SERVICE FOR ONNA-3