Specifications

WARNING
Verify Both Power Switches Are
Off Before Cleaning Case.
HIGH
PRESSURE
Verify that both switches were turned are OFF dur-1.
ing pre-cleaning. Both switches are located behind
the upper access door.
Always clean from the top down.2.
Remove all product stops, wire racks, removable 3.
tag moldings and deck pans.
Remove and clean the honeycomb discharge grill. 4.
A sink lled with warm sudsy water will simplify
this task. It may be necessary to use spray deter-
gent and a soft, long- bristle brush to get deep dirt.
Spray rear bafes (rear of case) with a mild clean-5.
ing solution, then wipe with a cloth or paper towels.
Spray shelves (starting at top) with a mild clean-6.
ing solution. Wipe each shelf (starting at the top,)
ensuring that the grove in the tag moldings is thor-
oughly cleaned.
Use a "no rinse" cleaning solution when cleaning 7.
the tank. Follow the manufactures directions. Never
allow water to ood the tank.
Spray the exterior of case with mild cleaning solu-8.
tion then wipe down with a cloth or paper towel.
Replace all tag molding, product stops and shelves 1.
removed during cleaning.
Spray the entire case including the coil, and tank 2.
area with sanitizer.
Allow to air dry. Any water remaining on the coil will 3.
turn into ice.
Replace remaining case components, deck pans, 4.
wire shelves and honeycomb.
Turn both switches ON. Both switches are located 5.
behind the upper access door.
Allow case to return to temperature BEFORE re-6.
turning product to case.
2
SANITIZING
CLEANING
P071253M SERVICE REV 0
IN- STORE SERVICE FOR ONNA-3